Zektor HD800-V2 Guía de usuario descargar pdf (Pagina 24)

HD1600V2 Serial Protocol, Version 1.4, 10/30/13

RS-232 / TCP/IP Port Hardware

TCP/IP settings used by the HD1600V2

Default IP Address: DHCP

Port Number: 50005

Duplex: Full

Speed: 10/100 Mbps

RS-232 Pinout and Baudrate Settings

The RS-232 port on the HD1600V2 is the same format, and pinout, as a PC modem, and uses the same

type of cable as a standard serial modem would, which is a standard straight through cable. Do not use

a cable that is marked as a “Null Modem” cable.

The HD1600V2 can also be used with USB to RS-232 conversion cables, these are all typically

straight through cables. (Be sure to install any drivers that come with the USB to RS-232 cable you are

using.)

The RS-232 port is a female type DE-9 connector (sometimes mistakenly referred to as a DB-9 con-

nector) with the following pinout:

Pin definitions

1 - No Connect 6 - No Connect

2 - TX 7 - No Connect

3 - RX 8 - No Connect

4 - No Connect 9 - No Connect

5 - GND

Port settings used by the HD1600V2

Baudrate: 19200

Data Bits: 8

Stop Bits: 1

Parity: NONE

Timing information (unless specified otherwise by a command’s description)

Min character to character time: 0ms

Min line to line time: 0ms

Min time between commands: 0ms

Max time to respond to a request: 100ms





1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 45 46

Sin comentarios

Zektor HD800-V2 Guía de usuario Pagina 24